OME Files C++

OME Files C++ Downloads
Licensing

Page Contents

Previous topic

OME Files C++ overview

Next topic

C++ conversion details

This Page

Building

CMake options

This project uses a standard CMake-based build. It may be configured and built using any supported CMake generator using any of the standard CMake options and variables, plus the additional project-specific options detailed below. Run cmake -LH to see the configurable project options; use -LAH to see advanced options. The following basic options are supported:

doxygen=(ON|OFF)
Enable doxygen documentation. These will be enabled by default if doxygen is found.
extended-tests=(ON|OFF)
Some of the unit tests are comprehensive and run many thousands of tests. These are enabled by default, but by setting to OFF a representative subset of the tests will be run instead to save time.
extra-warnings=(ON|OFF)
Enable or disable additional compiler warnings in addition to the default set. These are disabled by default since they trigger a large number of false positives, particularly in third-party libraries outside our control.
fatal-warnings=(ON|OFF)
Make compiler warnings into fatal errors. This is disabled by default.
relocatable-install=(ON|OFF)
Make the installed libraries, programs and datafiles relocatable; this means that they may be moved from their installation prefix to another location without breaking them. If OFF, the installation prefix is assumed to contain the libraries and datafiles. If ON, no assumptions are made, and a slower fallback is used to introspect the location. In all cases the location may be set in the environment to override the compiled-in defaults. This is OFF by default for a regular build, and ON by default for a superbuild.
sphinx=(ON|OFF)
Build manual pages and HTML documentation with Sphinx. Enabled by default if Sphinx is autodetected.
sphinx-linkcheck=(ON|OFF)
Check the validity of all internal and external documentation links. Disabled by default. If set to ON, the build will fail if any links are invalid; if set to OFF, the linkchecking targets will not be run automatically, but may still be run by hand.
test=(ON|OFF)
Enable unit tests. Tests are enabled by default.